This article was posted 11/20/2006 and is most likely outdated.

Newsletter Member Needs Help
 

 
Subject - Newsletter Member Needs Help

November 20, 2006  

Ask a Question |  Weekly Code GraphicQuizzes |  Free Stuff InstructorsOnline Training Products | Seminars | SubscribeUnsubscribe
[ image1 Post Comments | View Comments | Notify Me When Comments Are Added ] Web Page Version [Printer-Friendly]    

Newsletter Member Needs Help

Mike,
In December of 2005 I had two water leaks in my front yard, caused by pin-hole leaks in my copper water line. The leaks in the pipes were from the street to the house, thus the responsibility to repair was left up to me and not to the water supplier. My home is 4 years old and I do not understand why I should have such a problem with a newer home.

I called a plumber to repair the two leaks and from what he says it appears to be either a problem with bad copper piping or electrical current going through the copper pipes. Because I was not the original owner of the home, but the second owner, the builder said they were not responsible to repair the leaks. Remember, this was back in December of 2005. Well, this week my neighbors on both sides of me have encountered the same problem with water leaks. Although they have not had their problems repaired yet, the plumbers that have looked at their leaks do confirm that it is again, either bad pipes or electric current passing through the pipes. I do have a ground wire running from my electrical box and grounded on the inside to the copper water pipe line.

Also I have found out that all the wiring (i.e. phone, cable, gas, electric) is in a tunnel ditch going across the copper water line from the water meter to my house. I live in Kentucky were the building codes permit such utilities to be tunnel placed as such.

Mike Holt Comment: It's my understanding, based on studies by the American Water Works Association (AWWA), that alternating current flow does not create this problem. I'm willing to change my opinion if someone has a study to support the claim that pin hole leaks can be created in metal piping because of current flow. Do you have any thoughts?

 

[ View More Newsletters ] [ Send to a Friend ] [ Post Comments | View Comments | Notify Me When Comments Are Added ]

Copyright © Mike Holt Enterprises, Inc. All rights reserved.
This article is protected by United States copyright and other intellectual property laws and may not be
displayed or published on the internet without the prior written permission of Mike Holt Enterprises, Inc.

http://www.MikeHolt.com     1-888-NEC-CODE (1-888-632-2633)

Experiencing a Problem? Contact our Webmaster

Comments
  • If not an electrolysys problem(which I doubt seriously) I would ask if the water supply has done any repairs recently (within your vacinity) which involved chlorination to sanitize the work site. I recently encountered a similar problem - new pool, less than a year old. Heater pumps sucked up undesolved chlorine granules (used to shock the algea in the pool). Ate up the copper lines( chlorine and copper doesn't sit right to begin with). The other thing was entrained air inside the piping -"cavitating" - especially after the meter and smaller devices and fittings, created vortexs which often sounded like marbles in a glass, Won't take long to pit copper tubing.

    edt

Reply to this comment
* Your Name:
   Your name will appear under your comments.

* Your Email:
   Your email address is not displayed.
* Comments:

This newsletter is closed to new comments.

Email Notification Options:
Notify me when a reply is posted to this comment
Notify me whenever a comment is posted to this newsletter