This article was posted 12/08/2008 and is most likely outdated.

Interesting Question from an Engineer
 

 

Subject - Interesting Question from an Engineer

December 8, 2008
This newsletter was sent to 30563 newsletter subscribers
Ask a Question |  Weekly Code Graphic |  Quizzes |  Free Stuff |  Instructors | Online Training |  Products | Seminars | Subscribe | Unsubscribe
[ image1 Post Comments | View Comments | Notify Me When Comments Are Added ] Web Page Version [Printer-Friendly]    

Interesting Question from an Engineer

Mike,

I’d like to ask your opinion on compression couplings versus set screw type. I work for an A & E firm and have been an electric power engineer for 48 years, and counting.  Our company standards call for compression couplings exclusively and have for as long as I know.

 

However, contractors who I respect for their experience and integrity (which is not all of them) state that set screw fittings are equal and in some ways better than compression.  And I think I agree, at least do not disagree, as I do not and never have regarded conduits as grounds. That being the case, I see little reason for compression couplings in most of our projects which are not in areas of high vibration, long vertical runs, long distanced between supports, conduit abuse, etc.

 

Your thoughts would be welcome.

 

Thanks, Kevin Cassidy

 

Mike Holt’s Response: Kevin, I never could figure out why compression fittings were part of specifications; to me SS fitting are equal to or better than compression fittings.
Click here to post a comment
[ View More Newsletters ] [ Send to a Friend ] [ Post Comments | View Comments | Notify Me When Comments Are Added ]

Copyright © Mike Holt Enterprises, Inc. All rights reserved.
This article is protected by United States copyright and other intellectual property laws and may not be
displayed or published on the internet without the prior written permission of Mike Holt Enterprises, Inc.

http://www.MikeHolt.com     1-888-NEC-CODE (1-888-632-2633)

Experiencing a Problem? Click Here
 
Comments

  • Set screw versus compression - consider this:

    What type of connection would you prefer when joining the service drop to your service entrance conductors - compression or set screw?

    Which is more likely to become a loose connection over time?

    Now, extend your reasoning to conduits.

    Tom
Reply to this comment
* Your Name:
   Your name will appear under your comments.

* Your Email:
   Your email address is not displayed.
* Comments:

This newsletter is closed to new comments.

Email Notification Options:
Notify me when a reply is posted to this comment
Notify me whenever a comment is posted to this newsletter